: | Jul 15, 2008 |
. | Disconnect the battery ground cable. |
. | Remove the intake air shutoff throttle. |
. | Disconnect the low-pressure fuel lines.
![]() |
. | Disconnect both exhaust gas recirculation (EGR)
coolant cross-over pipe hoses.
![]() |
. | Remove the EGR coolant cross-over pipe.
![]() |
. | Disconnect the engine oil pressure (EOP) sensor
electrical connector. ![]() |
. |
Using the special tool, remove the oil filter element.
![]() |
. |
:
Remove the breather pipes. ![]() |
. | Disconnect the glow plug electrical connectors.
![]() |
. | Disconnect the low-pressure fuel lines.
![]() |
. |
:
Remove and discard the high-pressure fuel supply line.
|
. | Remove the low-pressure fuel line.
![]() |
. |
:
Remove the glow plug wires. ![]() |
. | Reposition the crankcase vent oil separator.
![]() |
. | Disconnect the fuel injection pump electrical
connectors. ![]() |
. | Disconnect the fuel rail pressure (FRP) sensor
electrical connector.
![]() |
. |
:
:
Remove the crankcase vent oil separator. ![]() |
. |
Position the crankcase vent oil seperator, but do not fully install at this stage.
|
. | Connect the FRP sensor electrical connector.
|
. | Install the crankcase vent oil separator. |
. | Connect the fuel injection pump electrical connectors. |
. | Install the glow plug wires. |
. | Install the low-pressure fuel line.
|
. | Install the new high-pressure fuel supply line.
|
. | Connect the low-pressure fuel lines.
|
. | Connect the glow plug electrical connectors. |
. | Install the breather pipes. |
. |
Install the oil filter element.
|
. | Connect the EOP sensor electrical connector. |
. | Install the EGR coolant cross-over pipe.
|
. | Connect both EGR coolant cross-over pipe hoses.
|
. | Connect the low-pressure fuel lines.
![]() |
. | Install the intake air shutoff throttle. |
. | Connect the battery ground cable. |
. | Check and top-up the engine oil. |
. | Check and top-up the coolant. |
. | Bleed the fuel system. |